1.54inch e-Paper Module Wiki: www.waveshare.com/wiki/1.54inch_e-Paper_Module_(C) Instructions video: www.youtube.com/watch?v=o2UK_lhnObw Video: https://www.youtube.com/watch?v=o2UK_lhnObw | Don't accept partial refresh. This is an E-Ink display module, 1.54inch, 152x152 resolution, with embedded controller, communicating via SPI interface, supports yellow, black, and white three-color display. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on. | SPI interface, for connecting with controller boards like Raspberry Pi/Nucleo, etc; No backlight, keeps displaying last content for a long time even when power down; Ultra low power consumption, basically power is only required for refreshing. | Operating voltage: 3.3V, Interface: 3-wire SPI, 4-wire SPI; Resolution: 152 152, Dot pitch: 0.181 0.181, Grey level: 2, Full refresh time: 27s, Refresh power: 26.4mW(typ.), Standby power: 170 | Interface Description: VCC:3.3V, GND: Ground, DIN: SPI MOSI pin, CLK: SPI SCK pin, CS: SPI chip selection, low active, DC: Data/Command selection(high for data, low for command), RST: External reset, low active, BUSY: Busy status output, low active.