✿I.Highlights.

Small size, light weight, easy to carry. Low melting point and high viscosity wax roller filling to simplify the hair removal steps.

✿II. Steps for use.

Step 1: Wash your skin well, making sure it is clean and oil-free, and apply Pre Wax Treatment Spray.

Step 2: Place the wax in the heater, turn on the power and wait 15 to 20 minutes for the wax to melt (liquid state).

Step 3: Remove the tape from the wax cartridge before use, and after testing the temperature with a small section of skin, apply it to the skin/strip of wax in the direction of hair growth.

Step 4: Apply the wax strip to the skin, sweeping the palm along the hairs repeatedly to flatten against the skin.

Step 5: Quickly pull the wax strip in the opposite direction of the hair growth. (Do not wax the same area of the skin more than once.)

Finally: Clean the area with After Wax Treatment Spray.

✿III. Notes.

1. Anti-hot hand design: no need to take wax in the machine after melting wax, handheld machine for waxing.

2. After heating the wax, it can last for about 30 minutes in 24℃ environment. If you need to use it for longer time, you need to heat it halfway.

3. If you have allergies, please stop using it.

4. Use After Wax Treatment Spray to remove residual wax, a little redness is normal after hair removal.

5. Don't take a shower immediately after waxing, you can use aloe vera lotion to soothe your skin.

6. Place the wax cartridge upright on a flat surface after waxing, do not put it flat to avoid leakage of wax.

7. This is a soft wax. When used again, the hard wax will solidify the exit due to long term storage. You will need to unlock the wax roller to make it slide more easily.

8. Waxing of the face or bikini area is not recommended for non-professionals.

9. Please do not wax on damaged, burned or sagging skin.