PERFECT FIT - The lens hood is compatible with DJI Osmo Pocket 3. Precise design based on Pocket 3 camera lens, the lens sunshade is fit perfect. This sunshade does not affect power on/off or gimbal turning. (NOT include cameras and other accessories) | PREMIUM MATERIAL - Made of high quality and lightweight ABS plastic. This pocket 3 lens sun hood can prevent strong light and glare. Fine workmanship with comfortable use. It's durability, waterproof, wear-resistant, durable, and not easily deformed. | EFFECTIVE SHADING - This pocket 3 sun hood can reduce the interference of strong light. Effectively avoiding sunlight above and on both sides. This sunshade is designed with an widened opening. It can ensure the shading without affecting the shooting of the lens. During shooting, it can also provide protection for the lens to prevent collisions. | EASY TO CARRY - This Pocket 3 lens sunshade cap is easy to carry. Light in weight and compact in size. the weight is only 13 grams, size is 6.8*6.3*5.5cm. You can easily put it in your backpack and it doesn't take up much space. This camera lens hood is the best choice for lens sunshade when going out. | EASY TO INSTALL - This lens hood is easy to install and remove, and does not require any tools. Snap the lens hood into the right position while the canera is off. Adjust rear of the gimbal, and line it up with lens hood slot. After attaching the hood, turn on the camera and adjust the gimbal level. NOTE: It is recommended to use FPV mode, otherwise it may affect the shooting.