Product Name:
Holder Breadboard Kit for Arduino Raspberry Pi

Introdution:
-SunFounder RAB holder Breadboard kit is suit for kids and beginners, developing and cultivating logical thinking, programming thinking and hands-on design skills.
-This RAB Holder Kit provides you with all the necessary components for a simple experiment, including threads for easy screwing, slots for plugging wires, an RAB holder, nine LEDs, and ten 1K current-limiting resistors, thus you can start the experiment right away.
-It can be used for Arduino R3, Mega 2560 & Raspberry Pi 4B, 3 Model B+, 3 Model B, 2 Model B and 1 Model B+ A+

Specification:
1. Wide compatible RAB holder supports your board for Arduino and Raspberry Pi, keeping everything convenient and neat, free of careless short circuits on a metal desk or caused by some metal parts underneath.
2. Quality solderless breadboard, often used to build and test circuits quickly before finalizing any circuit design.
3. Male to Male flexible jumper wires, totally 65 pieces in several types of length and many colors, therefore, you can just plug them into the control board and breadboard to build circuits, no bothering about complicated soldering.
4. A T-shape Extension Board which extends the pins of Raspberry Pi can be directly plugged into a breadboard.
5. The Screw holes with threads for easy screwing.
6. The slots for plugging wires conveniently.
7. The rubber feets effectively stop the RAB holder from slipping.

Package Included:
1 x RAB Holder
1 x 830-Point Breadboard
1 x T-shape GPIO Extension Board
1 x 20cm 40pin Flat Ribbon Cable
65 x Jumper Wire
10 x 1kΩ Resistor
9 x LED (3 red, 3 yellow, and 3 green)
12 x Screws
1 x Screw driver
6x Rubber Feets