Power Rating: 300 watts | Connector: SO-239 coax connectors have Teflon internal insulation | make direct electrical connections to the antenna | increase the efficiency of any amateur station

* Eliminate Stray RF from Amateur & CB Radio Antenna Feedlines. | * Helps Reduce Interference & TVI. | * For 1.8-30Mhz HF uses. | * 1:1 , 50 Ohms; Accepts Coax cables with PL-259 Connectors.

Multi-band center-fed dipole antenna capable of 1500 Watts. It consists of 52 feet flat-top fed with 17 feet of 450 Ohm matching section ending in an SO-239 coax connector.

Frequency range: 1.3-225, 350-540 MHz. | Output: 2 x SO-239 | Power (Watts): 200 | Insert Loss (dB): .20, VSWR: <1 .2 | isolation (db):> 55, Impedance (Ohms): 50

Don`t be fooled by competing products claiming fast search times -- if you have a quarter of the matching solutions, of course, it takes less time to finish but its not faster. | MFJ`s faster speed comes from advanced technology and software algorithms not from fewer matching solutions. | An easy-to-read, two-line, 16-character backlit LCD displays SWR, peak or average forward/reflected power, frequency, antenna 1 or 2, L/C tuner values, on/off indicators and other info. They are selected from easy-to-understand menus; not complex combinations of buttons you can`t remember. | A fast-response, high-resolution bargraph gives you an auto-ranging 20/200 Watt power meter. You get 60 segments each for forward and reflected power and 36 segments for SWR -- try that with an 8 segment bargraph that makes you change power ranges and doesnâ€â„t even give you reflected power! | StickyTune mode gives you one-hand tuning by locking the TUNE button; just transmit to tune regardless of SWR.

Full 1.8-30MHz Operation Custom designed inductor switch, 1000 volt tuning capacitors, Teflon insulation washers and proper L/C ratio gives you arc-free no worries operation with up to 300 Watts 1.8 to 30 MHz | Tunes any Antenna Tunes out SWR on dipoles, verticals, inverted vees, random wires, beams, mobile whips, shortwave receiving antennas.... Nearly anything! Use coax, random wire or balanced lines. Has heavy duty 4:1 balun | Custom Inductor Switch The inductor switch is the most likely component to burn up in any antenna tuner. MFJs inductor switch in the MFJ-949E was custom designed to withstand the extremely high RF voltages and currents that are developed in your tuner. | 8 Position Super Antenna Switch Lets you select two coax fed antennas, random wire/balanced line or built-in dummy load through your MFJ-949E or direct to your transceiver. | More hams use MFJ-949s than any other antenna tuner in the world! Has MFJs full size 3 inch lighted Cross Needle Meter (not a puny "meter" you cant read). Lets you easily read SWR, true peak forward and average reflected power simultaneously on 300 Watt or 30 Watt ranges. Lamp has on/off switch, requires 12 VDC or 110 VAC with MFJ-1312D (Not included)

Automatically match antennas with impedance of 12 to 800 ohms * Handle 600 watts PEP SSB/600 watts CW * Tune in less than 15 seconds, usually less than 5 seconds | Over 10,000 non-volatile memories for tuner settings * Highly efficient switching L-network matching circuit * 1.8 to 30 MHz continuous frequency coverage | Adjustable target SWR 1.5 to 2.0 * Adjustable SWR threshold 0.5, 1.0, or 1.5 * Lighted cross-needle SWR/wattmeter with high, low, and auto range options | Built-in frequency counter * SO-239 coax fed antenna connector * Connector for random wire or single wire antennas | Optional remote control * Optional radio interface for compatible radios * Requires 12 Vdc at less than 1 amp for operation

designed to reduce noise or interference, or improve desired signals, before the noise affects sensitive receiver circuits. | Frequency Range of 1.8 to 30 MHz | Works All Modes: SSB, AM, CW, FM | Easy to use

MFJ-115 Clock, 12/24-hour, analog, 12in

1/2 Wave Wire Antenna | Range: 80 to 10 Meters | Full HF Coverage | End-Fed Horizontal Wires | Broad-band Matching | 300W Capacity | No Tuner Needed for Most Frequencies | One High Center or End Support Needed | Color: Black | 1 Year Manufacturer Warranty

IMPEDANCE: 50 OHMS VSWR: Less than 1.3:1 at less than 650 MHz | POWER DISSIPATION: 1500 Watts for less than 10 seconds - 100 Watts for 10 minutes | VOLTAGE GRADIENT: 10 kV/in | OPERATING TEMPERATURE: Up to 350C | FREQUENCY RANGE: 1-650 MHz; usable to 750 MHz

Test Equipment, Dummy Load, Air Cooled | 1,500 Watts Intermittent Power Rating | 0-60 MHz Range | Use them for testing/tuning transmitters, transceivers, amplifiers, antenna tuners, baluns, transformers, filters, matching networks, coax, stubs, transmission lines, and antennas. | 3 Inch Cross-Needle SWR/Wattmeter

2-Line LCD Display | Built-In CoaxCalculator | Range: 530 KHz to 230MHz + 415-470 MHz | Can Be Battery Powered or AC Power with MFJ-1312D (Not Included) | 1 Year Manufacturer Warranty

SSB FM, AM, and CW never sounded so crystal clear | Size: 3.250W x 3.00H x 2.250D Inches | 6 ft. power cord | Speaker Type: Base station | Speaker Audio Input Connector: Mono 1/8 in. male plug

Key And Read, No Calibrating! | Great for HF, CB , VHF , Marine, MURS and More! | 30 or 300W Selectable!

Maximum Power Range: 3,000 W | Meter Frequency Range: 1.6-60 MHz | Meter RF Connector Type: UHF female, SO-239 | Middle Power Range: 300 W | Minimum Power Range: 30 W

Deluxe Meter Reads Power & SWR from 140-525Mhz for VHF/UHF Transceivers. | Great for Amateur Ham Radio, VHF Marine, GMRS, Public Service & V/U Commercial bands. | Compact size - 3.35 x 3.45 x 3.75 inches. Accepts PL-259 Inputs for Antenna & Radio. | Illuminates when connected to a 12Vdc source. | Power ranges of 15/150 watts forward, and 5/50 watts reflected. Cross needle design displays SWR, forward & reflected power simultaneously at a glance, without any calibration.