Converts Secure Digital Card into IDE compatible hard drives. | Compact Design4-pin computer power supply connector. | Bootable solution for PC.You can install the OS onto the SD Card. | The data transfer rate is high and the speed is almost the same as that of the system hard disk (ATA/133, U-DMA mode3). | Compatible with MMC system specification 2.0 , SD Memory Card specification 1.0, SDHC Memory Card.Compatible with DOS, Linux, Windows 98SE, Me, 2000, XP and Vista.

If there are no farad capacitor to protect the car battery, the car battery will be damaged faster than normal speed.So this item is a farad capacitor for car use. | It can make the voltage steady and reduce the wastage of battery. | Overvoltage output signal. | Up to a million times charge-discharge cycle life or 10 years DC. | With resistance or active monomer equalizing function.

CJMCU-FT232H is a single channel USB 2.0 Hi-Speed (480Mb/s) to UART/FIFO IC.USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible. | It has the capability of being configured in a variety of industry standard serial or parallel interfaces. | Entire USB protocol handled on the chip. No USB specific firmware programming required. | Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design. | UART transfer data rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter).

High performance 10/100 Ethernet transceiver (PHY), ultra low power design, can be powered from a single 3.3V supply. | The RMII interface greatly reduces the control pins of the MCU. The chip is packaged in a 24-pin QFN package (4x4 mm) and is lead-free. | Support HP Auto-MIDX, flexible power management architecture. | Integrated 1.2V regulator, IO voltage range: +1.6V to +3.6V. | Application areas: embedded server, development board Ethernet interface.

Silent designing, large air volume.Superior thermal performance.Special bottom design improves the efficiency of heat transfer.Complete sealed structure, isolating the moisture in the air | This cooling fan is suitable for cooling in a small space. The main unit of the air-cooling equipment is water for heat dissipation.Great DIY kit for electronic enthusiasts in semiconductor cooling applications | What you do get, is a sturdy heat sink, a small 12Vdc fan, a water heat exchange block, a bottom clamp bar, and some basic hardware(Peltier module not included) | Water block connections fit 3/8" tubing just fine. The "base board" is a stronger bar 5mm x 12mm bar. Fan is 12Vdc 0.09A, heat sink fits the 40mm X 40mm water block well, it could fit up to 45mm X 49mm | Note:There is nothing in the kit that is "thermoelectric" and nothing that "refrigerates".You assemble it yourself,with your own heat sink compound.It is suitable for a 12706 sized module

Recessed design, completely without wasting breadboard space | 2 Channel distribution can be disconnected, you can choose 5V, 3.3V voltage | Can be powered via USB and DC power head | Fit for: MB-102 Breadboard | Input Voltage: DC 6.0-12V(Or USB power supply)

Material: Plastic | Color:Black | Type: Talk PTT Button | Perfect to replace the old PTT Button | Compatible with Model: Motorola A10 A12 Two Way Radio