Application Instruction
1.Choose your desired design , Cut with the gloss side facing DOWN and the duller back of the vinyl facing up
2.Cut it onto the vinyl sheet with a craft cutter.

*Settings may vary based on blade condition and age of machine.

3. Weed out the excess
4. Heat and Transfer
Place the sheet with your design on to your shirt

Home Iron:
-Please Heat the iron on medium setting (302°F- 320°F);
-Press each section of the design with medium/firm pressure for 10-15 seconds;
Heat Press：
-Preheat garment for 2-3 seconds;
-Apply design at 305℉;
-Use medium pressure for 10-15 seconds;

5.Cool Peel
Peeling the clear pet film after the vinyl turns cold, just in 15-30 seconds later for the vinyl to cool down.
*If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl.

Warm Tips
1.Make sure there are no wrinkles on the material.
2.If you are having trouble, try turning the shirt 90 degrees and pressing again, this should eliminate problems from cold spots.
3.If you've already ruined one shirt, keep using it to experiment. Cut small pieces of heat transfer and try raising or lowering your temperature, or pressing longer or for less time.

Do not use nylon,velvet,acrylic fabrics,leather,vinyl which will melt and ruin the material. Hand wash your fabric gently with mild detergent. Wait 24 hours after application to wash. Turn the article of clothing inside before you wash it. No bleach. We recommend you to perform a test prior.
Quickly and easily apply the transfer vinyl to fabric using a hot iron or heat press; We recommend using on COTTON, POLYESTER, COTTON/POLYESTER BLENDS, LYCRA fabric for best performance.

NOTE: Actual color of heat transfer vinyl may vary slightly due to differences in monitor display.