Installation Steps
1.Fixing the heat sink with screws
Step 1: Clean the sides of the M.2 SSD with a wet wipe and dry with a dry towel.
Step 2: Place a silicone pad (0.5 mm pink) on the aluminum back cover. Make sure there is no semi-circular space covered.
Step 3: Place the M.2 SSD on a thermal silicone pad. Make sure to align the semi-circular space of the aluminum back cover.
Step 4: Remove the double-sided protective film of the light blue thermal silica gel pad.
Step 5: Place a silicone pad (1mm blue) on the front and try to place it in the middle of the M.2 SSD, gently press it with your finger.
Step 6: Place the heat sink on the silicone pad and align the screw holes.
Step 7: Fix the heat sink to the back cover with 6 screws.

Warning: Do not allow the heat sink to touch the metal end of the M.2 SSD during installation, as this may cause a short circuit.

2. Fixing the SSD cooler with screws
Step 1: Clean the side of the M.2 SSD with a wet wipe (bag, No. 1) and dry it with a dry towel (bag, No. 2).
Step 2: Remove the double-sided protective film of the light blue thermal silica gel pad.
Step 3: Place a silicone pad (1mm blue) on the front and try to place it in the middle of the M.2 SSD, gently press it with your finger.
Step 4: Place the heat sink on the silicone pad and align the screw holes.
Step 5: Fix the ends of the heat sink with 2 rubber bands.

Specification
Support equipment: m.2 solid state drive
Thermal conductivity: 2.0W/m·K
Size: Screw fixing ssd heat sink: 7.7cm*2.2cm*0.6cm
Heat-resistant rubber ssd heat sink: 7cm*2.2cm*0.3cm
Material: Alumina
Colour: Black

Package Contents
Screw fixing ssd heat sink x 1
Rubber ring fixing ssd heat sink x 1
Thermal silicone pad x 4
Heat resistant rubber band x 2
Cleaning kit x 1

Note: We ship different color randomly( Black or Red)