ELEGOO photopolymer resin is a type of polymer that changes its physical properties when introduced to light. In the case of 3D printing , these are typically liquid plastic resins that harden when exposed to a light source, which works perfectly with our Photocuring resin

Usage condition :
1) Shake up the bottle before use and avoid direct sunlight and dusty environment
2) Do not drink it and keep it out of the reach of children
3) Please wear a mask and gloves when using to avoid direct skin contact and maintain indoor ventilation
4) If you got skin contact please wash away with waters immediately and if you feel discomfort please see a doctor ASAP.
5) Once the model is complete, please wash it with high 95% degree or higher ethanol alcohol for 30 seconds at least
6)If you don't use the resin please do not leave them in the resin tank over 48 hours or put them back to its original bottle and seal it.

Material Properties :
Curing wave-length: 405 nm
Hardness: 79.0 D
Shrinkage: 7.1 %
Viscosity (25°): 552.0 mpa.s
Liquid density: 1.100 g/cm³
Solid density: 1.184 g/cm³
Tensile strength: 23.4 Mpa
Elongation at break: 14.2 %
Curing time: 6-10 s
Color option: Grey, White, Green, Black, Transparent, Yellow, Blue, Red
Shelf life: 1 year