BIGTREETECH CB1 Heatsink | Specially designed for CB1, ensure good heat dissipation | Durable material, simple and beautiful appearance

BIGTREETECH CB1 Core Board Heatsink Kit

BIGTREETECH Heat Sink For CB2/BTT Pi 2 Control Board | Size: 25x35x10mm | Please align the heat sink with the two components on the CB2 to ensure proper installation.

💥Includes an additional heater protection circuit which protects against runaway heating on the bed and hotend heaters. By default, the heaters are off so if the MCU or MOSFETs are damaged, the heaters will shut down instead of enter into thermal runaway; | 💥The TFT35 E3 V3.0 display board has higher compatibility. It have UART serial port screen and 12864 screen two work modes; and have serial port screen mode. It supports SD card and U disk two printing modes. | 💥The TMC2209 stepper driver is not easy to lose steps and is in an ultra-quiet mode; the module has a large area of heat dissipation pad, which can reduce the temperature of the driver when it is working; the module supports three modes: STEP / DIR and UART. | 💥TMC Motor drivers can be used in SPI or UART mode by simply adjusting the onboard jumpers beneath each motor driver. Additionally you can connect or disconnect the TMC DIAG pin using an onboard jumper allowing you to use hard endstops or sensorless homing without the need to cut any pins. | 💥Integrates a AOZ1284PI power regulator which supports 12-24V power input and a maximum output current of 4A - enough to power external components such as LEDs and even a raspberry pi;