3D WALL PANEL INSTALLATION MANUAL1. PREPARATION FOR THE WALL All the basic wall must be flat, dry, clean and firm. If the wall is Aged , the surface must be painted with water-based seal primer to fix the loosen surface firstly.2. PREPARATION FOR THE WALL PANEL Open the box and take out the panles very carefully. Each 5pcs in one stack. Put the panels on the clear and dry floor for 24 hours to balance the moisture between panels and environment, to prevent excessive expansion or contraction after installation.3. MEASURE THE WALL Measure the size of wall to find out the central point of it, then mark vertically and horizontally. Arrange it on the floor by rotating the panels before attempting to install, ensuring correct installation of the desired pattern.4. INSTALL THE COMMODITIY ON THE WALL Put the heavy duty construction adhesive to the lower parts of panel back, to put the adhesive higher than the panel back. Apply the panels on the wall same as planned design, pressing the panels? edges to ensure all the panels adjoin the wall tightly, Clean the glue which is flow out of the panels. It will be better to set asideit two hours for drying, then move to the next step.5. CUTTING THE PANELS If meet the corner or electric outlet of wall part, we can draw line one the panel then use knife or electric saw to cut panels freely according to the line to fit the wall suituaion.6. CUT EDGES TRIMMING AND PAINTING If the cut edges of panels meet the corner or end of wall, fill the cut edges with sheetrock compound/acrylic caulking. If additional finish is needed, paint the panels with oil base lacquer.